On-Boarding the Collector to Cloud

You must create a Home & a Collector in the Cloud Platform before on-boarding a Collector Unit. You will need the Engineer Code from within the Home page & the Device Authentication Code from within the Collector page in the  Cloud Platform before On-Boarding.

The security module attached to the Single Board Computer will flash (Blue Led) once every 3 seconds in normal operation. If the security module is continually flashing then the collector has not booted correctly or is still booting. Allow 1-2 mins for the collector to boot.

Tip: If using Ethernet, connect this before applying the network settings, then you can test the ethernet connection immediately when applied. Using ethernet means you can have your laptop connected to both the ethernet network of the care home, and the WiFi configuration network simultaneously in case any changes are required, simplifying installation.

Tip: Onboard the Collector using your own high speed network, this way any issues with the customers network or internet will not hamper the installation of pulling the data and the app dependencies. Its also good practice to ensure and test no issues are evident before installing on the customers network.

Power on Collector using the official power supply supplied, leave to boot for 1-2 mins

Connect your laptop or similar device to the Collectors Wi-Fi network broadcasted as OnsiteConfig, enter the password, Password123

Open a Web Browser on your laptop or similar device & browse to the IP address http://192.168.150.1

Choose between Ethernet or Wi-Fi

Ethernet - Insert the IP Address, Subnet Mask, Gateway, Primary & Secondary DNS & press Save.

Wi-Fi - Insert the  SSID, Password, IP Address, Subnet Mask, Gateway, Primary & Secondary DNS & press Save.

Allow for the network settings to apply for 1 min and then refresh the page.

If you get an error, you should check that the connection to the OnsiteConfig network has automatically reconnected.

Enter the Engineer & Device Authentication Codes to bind the collector to the specific Home created in the Cloud Platform & press Save.

Retrieve the Engineer code from the homes page in the Cloud platform.

Retrieve the Device Authentication Code from Homes > Manage > Collector

Once both codes are entered the Collector will begin to communicate with the cloud site and will start to pull dependencies, configurations & updates. On a good internet connection this will take on average 10-12 mins to complete.

Once complete you will receive the below success message! Your collector can now start to receive Nursecall alerts and mobile app users will be able to connect!

Now this is complete you can read about accessing OMU for ongoing management of the collector.